About the Aqua
bot pool cleaner

Aquabot filters and circulates your pool
water as it scrubs walls and floors!
Low voltage operation makes an Aquabot
fully independent of pool's filter system.
Aquabots trap debris (even sticks and
acorns) in their own easily removable bag.
Every Aqua
Products' robotic cleaner comes equipped with a computerized
microprocessor and sensors that allow it to adjust to any
shape, size and type of pool. This brain allows the Aquabot
pool cleaner to brush, scrub, vacuum and filter the full
length and breath of the pool. Such advanced technology
allows the Aquabot to climb the walls and most steps, work
around ladders and raised drains, and go into and around
corners.
The Aquabot Mark
V pool cleaner reverses itself as it works up the walls to
the water line, slightly changing the angle before
descending the walls to clean new areas. Every seventh time
your aquabot climbs the wall, it travels along the inside
lip of the pool below the coping giving the waterline and
tile above it scrubbing attention.
Aqua Products'
technicians install the microprocessor in every unit by
hand. Every cleaner is tested and inspected to maintain the
highest level of quality. Before installation, the
microprocessor is preprogrammed so that it will adjust
to virtually every pool and pool environment. When Aquabots
encounter an obstacle, a raised drain, ladder, wall or
corner, they instantly adjust and continue to clean.
- NO INSTALLATION REQUIRED
- BUILT IN FILTRATION
SYSTEM, FILTERS DOWN TO 2 MICRONS!
- REMOVES ALGAE AND
BACTERIA
- CLEANS ANY SHAPE, SIZE
OR TYPE POOL
- FULLY AUTOMATIC,
REQUIRES NO SUPERVISION
- PRE-PROGRAMMED FOR
EFFICIENT AND THOROUGH CLEANING OF POOL
- CLIMBS AND CLEANS POOL
SIDEWALLS, STEPS AND TILE LINE
- VACUUMS UP ALL TYPES OF
DEBRIS, EVEN ACORNS AND SMALL STICKS
- SCRUBS HARD TO REMOVE
DIRT
- OPERATES ON ONLY 24
VOLTS, AND HAS AUTOMATIC SHUT OFF
|